Edimax EW-7303APn v2 Guide d'installation télécharger pdf (Page 13)

Step5: Complete the hardware installation as diagram at below

Notes: Use Reset button on POE injector. Push continually the reset button of POE injector about 5 ~

10 seconds to reset the configuration parameters to factory defaults.

There is no software driver or utility installation needed, but only the configuration

setting. Please refer to chapter 4 for software configuration.

Notice: It will take about 50 seconds to complete the boot up sequence after powered on the Outdoor

Router; Power LED will be active, and after that the WLAN Activity LED will be flashing to show the

WLAN interface is enabled and working now.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 70 71

Pas de commentaire

Edimax EW-7303APn v2 Guide d'installation Page 13