Edimax EW-7415PDn Manuel d'utilisateur télécharger pdf (Page 11)

Chapter II: System and Network Setup

2-1 Installing the access point to your Network

Please follow the following instruction to build the network connection between your new

wireless access point and your computers, network devices:

1. Connect the access point to ADSL modem, router, or switch/hub in your network through

the LAN port of the access point by Ethernet cable.

2. Connect the A/C power adapter to the wall socket, and then connect it to the ‘Power’

socket of the access point.

3. Please check all LEDs on the front panel. ‘PWR’ LED should be steadily on, LAN LEDs

should be on if the access point is correctly connected to the ADSL modem, router or

switch/hub. If PWR LED is not on, or any LED you expected is not on, please recheck

the cabling, or jump to ‘4-2 Troubleshooting’ for possible reasons and solution.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Pas de commentaire

Edimax EW-7415PDn Manuel d'utilisateur Page 11