Edimax N-9210TX-64 Guide d'installation télécharger pdf (Page 4)

1. Plug the Wi-Fi extender into a power outlet close to the root wireless

access point and switch it on (1). The extender will automatically initialize.

In a few seconds, the Power LED ( ) will light up. Approximately 30

seconds afterwards, the Wi-Fi LED ( ) will begin to flash rapidly and

irregularly (2). This indicates initialization is complete. Please do not

proceed to step 2 until these conditions are fulfilled.

2. Press and hold the WPS button on the extender for 2 seconds, until the

WPS LED ( ) starts flashing.

3. Press the WPS button on the root wireless access point within 2 minutes to

establish a connection. The amount of time the button should be held

down will vary between different routers, some will work with a quick

press, while others may require holding the button down for 2 seconds or

more.

(1)

(2)

1 2 3 4 5 6 7 8 9 ... 18 19

Pas de commentaire

Edimax N-9210TX-64 Guide d'installation Page 4