Edimax IC-3110P Manuel d'utilisateur télécharger pdf (Page 146)

145

c. If you’re connecting this camera from Internet, it

could be caused by a slow Internet connection, and

it’s not a problem caused by camera. However, when

the network connection is slow, you should use lower

frame rate / resolution.

d. Adjust the antenna if you’re using wireless

connection. The antenna should be perpendicular to

the ground to get best reception, and the distance

between network camera and computer / wireless

access point should not be too far.

e. Try to adjust ‘MTU’ setting if you’re using PPPoE to

connect to Internet. Ask your ISP or network

administrator for detailed instruction.

Network camera is

not responding

a. Is the network cable or wireless connection

disconnected? Please check it.

b. Unplug the power adapter from wall socket and

plug it in again after 10 seconds, then try to connect to

the network camera again.

c. If network camera is correctly powered (‘Power’

LED is on), but you still can not connect to the camera

when you’re sure that IP address is correct, please

contact dealer of purchase for help).

Image is fuzzy a. Adjust the focus ring on the camera until the image

becomes clear.

b. Use a soft cloth to clean the lens on the camera.

You can use cloth with water, but DO NOT use

alcohol or other chemical solution.

c. Try to adjust brightness setting.

d. If there’s any light at the place where network

1 2 ... 141 142 143 144 145 146 147 148

Pas de commentaire

Edimax IC-3110P Manuel d'utilisateur Page 146